Jump to content
  • 0

defender front seat back removal


Roger

Question


  • Member ID:  637
  • Content Count:  1
  • Reputation:   0
  • Joined:  09/15/2020
  • Status:  Offline
  • Last Seen:  

New to the forum and just  bought a 2020 Defender HD8.  Hope someone can help me out. Wife made camo seat covers for my defender bottom seat and they look great.  However, I was going to remove the seat back rest and cannot figure out how to get the seat pulled off.  I cannot ever find where the bolt attach the back rest?  Anyone know how to remove the back of the seat?

 

Thanks

Link to comment
Share on other sites

4 answers to this question

Recommended Posts

  • 0

  • Member ID:  133
  • Content Count:  691
  • Reputation:   151
  • Joined:  04/24/2019
  • Status:  Offline
  • Last Seen:  

The seat backs are held in place by two rubber grommets, pull forward (towards yourself) and they should pop off.🙂

Link to comment
Share on other sites

  • 0

  • Member ID:  274
  • Content Count:  639
  • Reputation:   112
  • Joined:  11/22/2019
  • Status:  Offline
  • Last Seen:  

On 9/15/2020 at 10:05 AM, Andystoy19 said:

The seat backs are held in place by two rubber grommets, pull forward (towards yourself) and they should pop off.🙂

Not the driver back... two torx within the square tubing about mid way. (A couple inches above crossbar) One per side...middle has pins.... passenger as noted above.... 

Good luck

1601521952472367172380433984828.jpg

Link to comment
Share on other sites

  • 0

  • Member ID:  1,030
  • Content Count:  47
  • Reputation:   5
  • Joined:  05/22/2021
  • Status:  Offline
  • Last Seen:  

ok i see the torx for the back seat on the drivers side but how does the drivers bottom seat come off? i am putting seat covers on also. i see that it has bolts in it but it almost looks like the whole seat frame comes out?

Link to comment
Share on other sites

  • 0

  • Member ID:  1,030
  • Content Count:  47
  • Reputation:   5
  • Joined:  05/22/2021
  • Status:  Offline
  • Last Seen:  

4 bolts hold the whole drivers seat in. take them out then the whole seat comes out then you can easily take the torx screws out. it takes a little bit to get the back 2 bolts out of the bottom seat but not bad.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...