Jump to content
  • 0

CanAm Defender headlamps


Jeff Irish
 Share

Question

2 answers to this question

Recommended Posts

  • 0

I would change one of the bulbs with one that the low beam works, it may be that both your low beam filaments are burnt? If the bulbs are good you will need to trace your wiring back to the switch using a volt/ohm meter.🙂

Link to comment
Share on other sites

  • 0

To test the switch... just flip switch and use a test light to see if power hits the middle posts... I believe the bottom posts are the hot leads middle posts are low beam... and upper posts are high beams...  My bet is FAULTY SWITCH!!! Others as well as myself have had switch issues... my switch happened to be a window switch...

Good luck

The entire panel that the light switch is in pops out.... allowing easy access to the back of that switch...

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.


×
×
  • Create New...