Jump to content

Tug Hill

Members
 View Profile  See their activity

  • Posts

    55

  • Joined

  • Last visited

  • Days Won

    4

Tug Hill last won the day on July 27 2021

Tug Hill had the most liked content!

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

Tug Hill's Achievements

Apprentice

Apprentice (3/14)

  • Dedicated Rare
  • First Post
  • Collaborator Rare
  • Week One Done
  • One Month Later

Recent Badges

15

Reputation

  1. Tug Hill
    Well done! and a nice write up. Please give and update on hoe the gear oil addition works out.
  2. Tug Hill
    Hi have a 6ft Western straight on my 19 HD10. I went with due to having tracks and V would be hitting the tracks. It still moves an impressive amount of snow...... Speaking of Snow I have to plow again in a couple of minutes
  3. BTAC.WLW

    Tug Hill, I am hoping you can help me.  I just installed the apache tracks on my defender.  I also have the Western Plow.  The tracks, when turning, will hit the plow mount.  Did you have a special bracket or spacers made?  Any help is appreciated.

    Thank you,

    sean

    1. Tug Hill

      Tug Hill

      I put a pair of these on and fixed it Clamping Two-Piece Shaft Collar, with Keyway, for 1" Diameter, 303 Stainless Steel | McMaster-Carr

      Good luck!

  4. Tug Hill
    Here's the &12.00 replacement switch from Spemco p/n VLD1G66B. There will be a plastic pin which need to get cut off. Other then that they wok great. I ordered 3 more this morning before i posted this!
  5. Tug Hill
    The bearings are sealed on LT bogie wheels.
  6. Tug Hill
    Coolant lines run under there
  7. Tug Hill
    19" HD10 and can do 100 miles with no problems. A coupled of stops and a walk about and it's all good.
  8. Tug Hill
    I think your confused, this is Can-Am Defender site(UTV's). not a Land Rover Defender forum.
  9. Tug Hill
    Give the folks at EPI a call and tell them what your planning. They'll get you set up correctly.
  10. Tug Hill
    Here ya go the parts on the floor are adapters and go on the frame, they just pin on. But they rattle without the mold board and pump installed.
  11. Tug Hill
    No, it mounts on the lower frame and the pump stays on the plow head/ frame when unhooked. Just the electrical plug on the front when not using plow.
  12. Tug Hill
    So their not as EZ to change out as they make it sound. It takes me about 3 hours to do a swap out, mostly because I'm working alone and I'm nuts about torqueing and alignment. Also how much mud? These things are heavy to say the least. I only run the Pre-filter on mine in DEEP snow with zero issues. Good luck with what ever you do.
  13. Tug Hill
    Just thinking a, Sled Deck type bed on the p/u and haul the camper. They have them that will load up a Defender.
  14. Tug Hill
    I use the OEM for the Maverick.
  15. Tug Hill
    They won't, I run mine fairly hard between plowing Lake Effect snow and working the woods it wears but never been torn up.
×
×
  • Create New...