Jump to content

TrueBlue

Members
  • Posts

    42
  • Joined

  • Last visited

  • Days Won

    6

Everything posted by TrueBlue

  1. Anyone running a portable AC unit on prior Limited Editions ??? I've seen Zero Breeze Mark 2 units and wonder if that will work. Also just a window unit with small Honda Generator sticking out back window ??? looking at any ideas you guys have. thanks TB
  2. Anyone know where I can get bed cover to fit the Defender or one made to fit my unit 60"wide and 39" long. I have a back rack so I lose 2" Something like the Cover My Bed one made for the Rangers. Plastic or Black Powder Coated Aluminum. Thx
  3. HI anyone on here got a good clean 2019 Defender Max HD10 XT stock gauge cluster with approx 3500 miles or 5500 Klm that they want to sell or was thinking bout upgrading to newer style but worried about cost this way you would be getting something for your old one. I busted mine and looking for one with similar miles. A new one has "0" miles and you can't put the mileage back on it according to the dealer ?? Thanks TB
  4. Think I might of found it based on these findings you guys posted. The rear roll cage bolts on that side were loose and I would if never found it until they fell out 😮 so tomorrow I'll will test and advise. Thanks. TB
  5. I have a 2019 HD10 Max Cab and when I hit a bump like a round rock protruding from the ground I get a clunk noise coming from the rear left driver side and seems like it's around the rear door and right under back window area on that side ??? Very annoying ! Thanks in advance TB
  6. Guys I replaced replaced my Drivers side power window twice under warranty and now again outside warranty. I’ve cleaned the contacts and it works for a couple of weeks the fails again usually in the upward motion. What other switches are you guys using as a substitute?? part# and manufacture if you have one. 2019 Can Am Defender HD10 Max Cab Thanks Bill
  7. Looking for a set of 14” x137 rims for HD10 Max Cab 5+2 offset so I can have two set of tires and rims to swap. Thx TB
  8. Make sure to run max air as rated on tire. No issues with clutching or turning them over. I use low gear when in hard rough areas. I’m at 7,000 Klm and original belt. cheers
  9. 2” is what I found to keep front and rear tracking in the same rut. Cheers
  10. Well it was the front Diff and they replaced it. Funny how one dealer said never heard of it before and another dealer said bring it in two hrs and you’ll have it back. I quess I have a new dealer going forward. 👍😀 TB
  11. A year later and that noise in the front end is still there and i’ve had enough. Today I took the drive shaft protector off the front section from steady/carrier bearing to the front Diff. I found the noise finally it’s that stupid Diff assy. Now it’s dealer time to see if they will replace or fix the issue ! Still under 2 yr warranty. TB IMG_3669.MOV
  12. Hi all, just wondering if this is a good suitable engine oil for the H10 ? thanks TB
  13. https://atvtirescanada.com/aluminum-wheel-spacers.html TB
  14. Those little fans are great as well for $11 each TB
  15. Also put on Race Driven pads and no more squeal ! Installed LED lights from Amazon . TB
  16. Replaced the pads which only had 800 klm and not worn at all. Put on the Race Driven and no squeal ! TB
  17. I didn’t remove the front drive shaft yet, I guess it’s just to much work and i’ll Live with the rattle for now ! TB
  18. I know everyone don’t have a air blaster but under due care and caution !! Starter fluid works great but just a small amount. 😜 TB
  19. I have the Maxxis Liberty ML3 30” on stock rims with 2” spacers in rear, no lift and the ride quality and handling is perfect. Highly recommend it. I don’t know why they don’t offer this option from factory or a dealer upgrade. Maybe they don’t know ?? TB
×
×
  • Create New...