Jump to content

Adding additional Power Terminals


Recommended Posts


  • Member ID:  338
  • Content Count:  265
  • Reputation:   72
  • Joined:  02/07/2020
  • Status:  Offline
  • Last Seen:  

Using the winch causes my light bar to flicker and radio to cut out, so I want to have them on a separate run/circuits. What setups have everyone used? Looking at relays to terminal posts. 

Right now everything is off the under the dash power block.

Link to comment
Share on other sites


  • Member ID:  1,660
  • Content Count:  145
  • Reputation:   31
  • Joined:  07/08/2022
  • Status:  Offline
  • Last Seen:  

i feel like the winch should probably have its own power source/cable but i dont think that is what mine has going on...  id have to check for sure to see where the dedicated winch setup is under the hood on the newer ones.  

steve

Link to comment
Share on other sites


  • Member ID:  338
  • Content Count:  265
  • Reputation:   72
  • Joined:  02/07/2020
  • Status:  Offline
  • Last Seen:  

2019's its attached to the posts under the dash where everything else is located.

It's a XT Max Cab machine, winch was factory installed.

Edited by Steelslinger
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...