adam

I will follow up on these. The fuse wasn't blown but for what the cost was I just replaced it. Now that you explained where the relay is. I replaced that too. I will have to run it as you suggested without having the fan controls on and see if the fan is working on its own or not. Thank you!

In regards to the rad fan, that was my question initially as I dont here it cycle on and off. I have had to resort to leaving the controlled fan on all the time to blow out hot air. I thought that was working until yesterday, I was only at 2 bars on the temp gauge then the engine shut off. I think your right with the relay, I had replaced the fuse already. I believe this is my temperature control sensor. It looks like it is cooked? What do you think.

So I got it to start by letting it sit and cool for 30 minutes. Then it started but only traveled a km then engine slowed to limp mode then stopped altogether. I will definitely check the fuse area. my lights were working, I did t check the winch button though. I should check that Thank you for the suggestions. Yeah I thought it was weird they didn't find any codes either.

Good day! I was hunting in the winter and while driving my HD10 2019 just quite running. The temperature gage showed it was overheating. I checked the coolant it was good. We let it cool down and it would not start. Took it in to get checked out at a canam dealer, they couldn't find anything wrong. The only thing I could find was a issue with the commanders, had a safety module that would stop the engine automatically if it was starting to over heat. Yesterday I was out in the bush and it did this to me and wouldn't start. Had to tow it out od the bush. Last weekend went on a tour with 6 of us no issues. Yesterday it was just me and it did this. Again the coolant was full. It seems like electrical issue. Reason I say this it started smoking underneath the steering wheel then stopped. Before wasting a ton of exploratory money on trying to figure out what the problem was I was hoping someone may have experienced similar issues and has resolved it, or someone may know what the issue is. Thanks in advance!