Jump to content

Jason

Members
  • Posts

    9
  • Joined

  • Last visited

Everything posted by Jason

  1. Looking for a service manual for my 2018 defender xt cab hd10. lost a front bearing repair time! Bearing went out with only 6000 kms on it. Not a long service life I guess.
  2. My front passenger side upper an arm is bent. Noticed when I was undercoating for winter. Is there any aftermarket arms that work with Apache 360 Lt tracks or d I have to stick with the own. Thx gang. J
  3. Jason

    Oil sweat

    Hey gang. 2018 HD 10 xt cab after this winter I noticed this in the pic. Seems to be bit of oil looking stain around the boot of this wiring harness. Anyone else have this happen? thx
  4. Ya. Will wait out till more folks chime in. Thx.
  5. K. Thx. Was there much grease in from the factory?
  6. Did u just remove the lower ball joint to get it to work or the works?
  7. 2018 defender xt cab. Hd10. Looking for the greaser tool for front and rear wheel bearings. Lots listed online but hoping to find one that works without removing drive shaft or ball joints. Read somewhere the x3 might work but ball joint must be removed.
  8. I will give it a try. Just wondering if this happened to anyone else.
  9. I have 2018 hd10. Just removed my tracks for another season and while inspecting everything I noticed 3/4 boots/clamps had moved a bit. Showing small amount of no paint metal. Is this normal! I think not or are the clamps low quality? What to sort this out and prevent future repairs.
×
×
  • Create New...